Analog-way MIDRA PLATFORM TPP Current Programmer's Guide Manuale Utente Scaricare il pdf (Pagina 6)

PROGRAMMER'S GUIDE FOR v01.02.11

2 CONTROLING MIDRA™

2.1 Introduction

Midra™ products are usually controlled by the user friendly RCS² or other high-end remote controller,

but a programming interface is also provided for automation applications.

A good practice is to setup the machine with the RCS² and then control it with a few basic commands

like “preset recalling” and “layer input change”.

2.2 Physical interfaces

Picture 1 : RJ45 leds colors definition

Midra™ can be controlled through its rear Ethernet RJ45

plug :

 labeled “ETHERNET”

 10Base-T or 100Base-TX (Auto-Sensing)

 MDI connection (which need a crossover cable to

connect it directly to a computer)

Midra™ can also be controlled through its rear RS232 DB9 female plug :

 labeled “RS-232”

 1200Bds up to 115200 Bauds

 3 wires straight cable, 8 data bits, 1 stop bit, no parity bit, no flow.

2.3 Protocol

Supported protocol is TCP/IP, parameters can be set up with front panel or RCS² configuration menus.

Default values are :

 Protocol : TCP or UDP

 DHCP client : no

 IP address : 192.168.2.140

 IP mask : 255.255.255.0

 Gateway : 192.168.2.1

 TPP port : 10500

Note : the simultaneous connection number is limited to 1.

Left LED

color

Definition

Right LED

color

Definition

Off

No link

Off

No activity

Amber

10 Mbps

Amber

Half-Duplex

Green

100 Mbps

Green

Full-Duplex

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Commenti su questo manuale

Nessun commento

Analog-way MIDRA PLATFORM TPP Current Programmer's Guide Manuale Utente Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Audio Analog-way MIDRA PLATFORM TPP Current Programmer's Guide